Jeremy, that was a typo. I indeed have been sending to correct email jeremy at ledseq dot com
I just tested turning on the unit without a card, and its not behaving correctly. It shows SD CARD on screen, but seems to suddenly turn off completely and ‘restart; after a few seconds. it’s a random type behavior. The red LED on the rear is either blinking (when SD CARD shows on screen) or solid red (when screen goes black).
Pressing both buttons and powering ON, shows a scrambled set of pixels in beige color and gradually alternates to red/orange. Doesnt seem a proper color test to me but I never knew what it SHOULD look like.
I am convinced this is a hardware failure of the board (not the screen). I may be wrong. Only one way to find out. Are you able to set me up with a new board, and I can replace it? Im handy with soldering so that’s not an issue.